Some of the wood for the guitar. Sitka Spruce top and Padauk back and sides, both from the Somogyi wood collection. Cocobolo for the fretboard.
The Padauk sides have grain running at an angle. They are wide enough though to cut out the sides with straight grain.
Trimming the sides.
Thicknessing the sides for bending.
Marking out the sides.
Starting the bending by hand.
The bending is roughed in by hand, and then the sides are put into the bending machine.
Sides in the bending machine.
Double sides bent, and head and tail blocks made.
Laminating the double sides.
Scraping the sides clean after laminating.
Sides laminated.
Mahogany strips for the solid lining.
These are all bent by hand and then bent in the bending machine.
Then they are laminated together, with the actual sides inside of the form too, to give them the correct shape.
Clamping setup for laminating the lining.
Solid lining cut out to follow the dome of the top and back.
Preparing the Padauk back for joining.
Back joined, and index holes drilled. Marking the back.
The back is roughly cut out.
Back and sides.
Preparing the Sitka Spruce top for joining.
Top joined, and marked.
Marking the rosette.
Rosette marked.
Top, back, and side.